The caller asked whether removing a board would allow the bent flashing to be replaced, or whether the surrounding stucco also had to be removed. The house was newly built. Our discussion covered replacing the damaged metal and restoring the appearance the caller wanted.
So you're not talking about cutting all the stucco out 8ft, you're just talking about going, removing that board and replacing that flashing or what?
We described how the flashing was fitted in this particular assembly. The bent metal was L-shaped and extended approximately three inches beneath the stucco. That overlap helped explain why the flashing replacement involved more than removing the board the caller had mentioned.
It goes beyond the stucco, underneath the stucco, like three inches.
The flashing was also secured with many nails. We explained that removing it would require removing the whole eight-foot section, including the stucco. Our proposed removal area was based on how far the metal extended beneath the stucco and how it was attached.
So to pull that out, we'll have to remove the whole eight feet.
We also mentioned removing only half, but questioned whether the owners would like the result. The caller made clear that restoring the appearance of the newly built house mattered. The amount of material removed was part of the discussion, but so was how the repair would look.
I want it like nothing happened.
The caller wanted the paint matched but did not know the existing color. We said we would take the paint-match sample from the metal rather than the stucco because we needed a flat surface. That was our proposed sampling method for this repair.
Yes, we would pull it off of the metal, not off of the stucco, but off of the metal.
When the caller asked how long the repair would take, we described one day of work, followed by painting the next day when dry. The anticipated total was two days. That timing was the sequence we discussed for this repair.
One day and then the next day when it's dry painting.
Our explanation connected the removal scope with the caller’s expectations for the finished appearance. We discussed removing the flashing and stucco, taking a paint-match sample, and the expected timing. These were proposed steps, not a report of completed work. The takeaway was to consider both the removal area and the intended appearance, rather than treat this plan as a rule for every flashing replacement.
Discuss the flashing repair scope with our team, including how you want the finished repair to look.